Paint, sheet metal, hood ornaments, trim, emblems, seats, carpet, dashboards, etc.
by Boots43 » Thu Nov 29, 2012 6:31 pm
My grill has a thin crack on one of the upright pieces that hold the square pieces and was wondering if anyone has tried to use something like JB Weld? I just don't want it to break all the way. I have an extra two grill sections but they are broke in a couple of spots also. I know they can be welded but wanted to try something easier. Any suggestions? Boots43
-
Boots43
- Junior Member
-
- Posts: 60
- Joined: Sun Oct 09, 2011 7:46 pm
by 58limited » Tue Dec 11, 2012 8:09 am
I've seen JB weld used on a few grills that I've gotten, seemed to hold just fine.
1958 Buick Limited Riviera Coupe Model 755
Other cars:
1953 Chevrolet 3100 Pickup
1957 Pontiac Transcontinental Safari
1968 Ford Galaxie 500 HT
1977 Lincoln Continental Convertible
-
58limited
- Site Admin
-
- Posts: 272
- Joined: Tue Aug 07, 2007 7:48 pm
- Location: SE Texas
-
by Boots43 » Sun Dec 16, 2012 5:33 pm
Thanks, I'll give it a try. Boots43
-
Boots43
- Junior Member
-
- Posts: 60
- Joined: Sun Oct 09, 2011 7:46 pm
Return to Body, Trim, Interiors
Who is online
Users browsing this forum: No registered users and 0 guests